Oliver 4065, Owner'S Manual, Page: 55 / 88

4065 Table Saw OLIVERMACHINERY.NET
55 |
Page
Maintenance
Routine maintenance keeps your table saw in optimal condition. Please follow the maintenance schedule
below and use the maintenance record worksheet attached to document all tasks completed.
NOTICE: Maintenance schedule may vary for individual users due to different situations and safety
requirements.
Task Frequency
Inspect the power switch, cord, and plug for signs of
failure.
Every day before any operation begins.
Inspect the saw blade for signs of damage. Replace
damaged/dull blades.
Every day before any operation begins.
Clean cast iron table and miter slots, then apply rust
protectant.
Weekly
Remove dust accumulated inside the cabinet. Monthly
Clean trunnion slides, worm gear, and elevation rails.
Lubricate with self-cleaning dry lube.
Every 6-12 months.
Inspect the anti-kickback pawls of the blade guard.
Resharpen as needed.
Every 6-12 months.
WARNING
Disconnect the machine from the power source before performing any
maintenance work. After servicing the table saw, remove all tools before
restarting the machine. Failure to comply can cause serious injury!
Dust Accumulation Removal
Inspect the cabinet and dust shroud monthly and remove dust accumulation as needed.
1. Disconnect the saw from the power source.
2. Open the dust shroud access panel.
3. Remove the thumb screw that locks the dust
shroud door.
4. The dust shroud captures most of the dust
produced. If dust accumulates inside the
dust shroud, remove the dust accumulation
with a vacuum.
5. Lock the dust shroud door and the dust
shroud access door before starting the saw.