Oliver 4065, Owner'S Manual, Page: 23 / 88

4065 Table Saw OLIVERMACHINERY.NET
23 |
Page
Test 1: Trunnion Inspection
1. Install the handle of the blade tilt handwheel
located on the left side of the table saw
cabinet. Check the blade tilt angle pointer in
front of the saw to make sure the blade tilt is
set to 0°. Loosen the blade tilt handwheel
knob, and make adjustments as needed.
2. This saw should arrive with the saw blade
and riving knife pre-installed. If not, see the
steps in “Changing Saw Blade” on page 39
and “Swapping Riving Knife / Blade Guard”
on page 40.
The zero clearance table insert should have
been cut and ready to use, and it should be
flush with the table. If not, see “Table Insert
Setup” on page 59.
3. Remove the table insert.
4. Loosen the blade height handwheel knob
and raise the blade to the maximum height.
5. Make sure the blade is mounted securely on
the arbor and the blade can be raised to the
maximum height. When using a 16” blade,
the blade height is 6-1/8" above the table.
The blade height is 5-1/8" when using a 14”
saw blade.
6. Make sure the riving knife is seated correctly
on the mounting bracket. The holes on the
riving knife must align with the pins on the
bracket, and the riving knife must be secured
by the flange and the mounting bolt.
7. Set blade tilt to 45°. The highest point of a 16”
blade is 4-3/8" above the table. For a 14”
blade, the blade height is 3-5/8".
8. Lower the blade to the lowest position, then
reinstall the table insert. Raise the blade to
maximum height again. The table insert
must not contact the blade at any blade
height and any blade tilt angle.