Oliver 4065, Owner'S Manual, Page: 29 / 88

4065 Table Saw OLIVERMACHINERY.NET
29 |
Page
19. Adjust the leveling feet of the extension
table legs so they provide adequate support
for the table without changing the levelness
of the table.
20. Mount the shelf end plate (#2) onto the
extension table legs using the M8 Philips
screws (#8) and M8 flat washers (#12).
Orient the shelf end plate so the screw holes
of the shelf brackets are close to the floor, as
shown in the picture.
21. Mount the shelf brackets (#3) using the
remaining M8 Philips screws (#8), spring
washers (#20), flat washers (#12), and nuts
(#19).
Please note that the screw holes on the
cabinet may be covered by decorative
stickers. Remove a small section of the
sticker to reveal the screw hole.
22. Mount the fence tube (#15). Align the screw
holes of the front rail and the fence tube.
Mount the fence tube with the M6 bolts
(#18), M6 spring washers (#21), and M6 flat
washers (#23). Make sure the fence tube
runs in parallel with the edge of the table
before tightening all bolts.