Oliver 4065, Owner'S Manual, Page: 32 / 88

32 |
Page Oliver Machinery 4065 Table Saw
Dust Collection
The use of the table saw will generate wood dust, which
is harmful to the body. This saw comes with a dust shroud
to capture the dust. Connect this machine to a dust
collection system to prevent the dust shroud from getting
clogged.
The minimum CFM requirement for this table saw is 500
CFM at the dust port, which means the dust collection
system should have a rating greater than 500 CFM, as air
friction and leakage can reduce effective CFM at the dust port.
IMPORTANT
Running this table saw without a dust collection system or using a dust collection
system with inadequate suction may damage the machine and cause other
hazardous situations. Check the dust shroud and the dust collection system
regularly to make sure it is not jammed or filled up.
Moving and Leveling the Saw
This table saw is equipped with casters, and it can easily
be moved around.
To move the saw, lift up all six leveling feet to the highest
position and move the saw with the casters.
To keep the saw stationary and leveled, lower the leveling
feet until the casters are lifted off from the floor.
Continue to adjust the leveling feet until the table is
leveled with the floor and the saw is not rocking. Then
adjust the leveling feet of the extension table to make
sure they support the far end of the extension table.
Lastly, try to push the saw and make sure it stays
stationary. The saw must not move during operation.