Okolab UNO-COMBINED-CONTROLLER, Manual

Page: 55 / 56

55
18 Figures
Figure 1 AC section wiring diagram
..................................................................................................... 10
Figure 2. System Overview.
.............................................................................................................. 11
Figure 3. Control Unit Rear Panel Overview
........................................................................................... 15
Figure 4. Complete gas lines scheme.
................................................................................................. 16
Figure 5. Complete gas lines scheme. Zoom sketches on the Inlet and Outlet connectors of the Humidifier and Zoom
sketch on the Inlet connector of the Chamber are reported.
........................................................................ 17
Figure 6. Avoid gas leak: make sure tubing is pushed all the way into the Push-in to-Fit connector
......................... 18
Figure 7.Input and Output gas ports. See symbol on the rear of Pressure Gauge.
............................................. 19
Figure 8. How to close the purging valve of the Pressure Gauge.
................................................................. 20
Figure 9. Pressure gauge using.
........................................................................................................ 20
Figure 10. Assembling instruction of the Bubbling Column and its parts
......................................................... 21
Figure 11. Cables connection. Standard configuration.
.............................................................................. 22
Figure 12. Objective Band Heater Selection Chart.
.................................................................................. 23
Figure 13. Objective Heater (OBJ-COLLAR ####) Assembly
...................................................................... 24
Figure 14. Free Sensor with male to male extending cable.
........................................................................ 27
Figure 15. Front Panel of the Control Unit
............................................................................................. 28
Figure 16. Free Sensor attached on the internal base of the Petri Dish.
.......................................................... 31
Figure 17. SENSOR LID-35. For 35 mm Petri-dish
.................................................................................. 32
Figure 18. Controller Display "Main Page" and function buttons
................................................................... 34
Figure 19. Main Page and Main Menu Navigation Description
..................................................................... 36
Figure 20. Main Menu Display. Changing Set Points Description.
................................................................. 37
Figure 21. Main Page when working with Free Sensor connected to the Control Unit.
........................................ 37
Figure 22. Offset Mode Selecting.
....................................................................................................... 38
Figure 23. How to see the current offsets in standard mode
........................................................................ 38
Figure 24. How to change the base offset value.
..................................................................................... 39
Figure 25. How to choose the Custom Offset Mode
................................................................................. 40
Figure 26. How to insert the custom offset values.
................................................................................... 41
Figure 27. Objective Heater Settings Menu.
........................................................................................... 41
Figure 28. Homepage when objective Heater is disabled.
.......................................................................... 42
Figure 29. Reset to factory default
...................................................................................................... 42
Figure 30. How to change the Objective Heater offset.
.............................................................................. 42
Figure 31. Ramp rate changing.
......................................................................................................... 43
Figure 32. Humidity Module Enabling.
.................................................................................................. 44
Figure 33. Main Page when Humidity Module is disabled.
.......................................................................... 44
Figure 34. Alarm Settings Menu.
........................................................................................................ 45
Figure 35. Visual alarm Active.
.......................................................................................................... 45
Figure 36. Temperature sensor fault.
................................................................................................... 46
Figure 37. Screen Settings Menu
....................................................................................................... 46
Figure 38. Product Info Menu
............................................................................................................ 47
Figure 39. Stop Mode display.
........................................................................................................... 47
Figure 40. Display when UNO-TS software is active.
................................................................................ 48
Figure 41. Flow meters graduated scales, example for two gas lines.
............................................................ 50
Figure 42. Flow meters graduated scales, example for Premixed as line.
....................................................... 51