Oki IP-6620, Maintenance Manual

Page: 204 / 572

OKI Data Infotech Corporation CONFIDENTIAL
Chapter 5 Troubleshooting (Engine Section and USB Controller Section)
5-45
<Description>
One of the following errors has been detected during automatic print adjustment.
1. Calibration lower limit error: The sensor light intensity is below the lower limit.
2. Calibration higher limit error: The sensor light intensity is above the higher limit.
3. Adjustment value determination error: A problem has been detected with the detection
results.
<Action>
Check the Items to be Checked on the table below, and perform the actions starting from the top
until the problem is solved.
No Items to be Checked Action
1 Firmware Upgrade the firmware to the latest version.
2 The media Try with a different media.
3 Restart the printer with the media
installed and check that POC is
skipped. If POC is not skipped, the problem is not with the media but
probably with the PCB-ASSY-ADJ1 path. Perform the
following solutions in the given order.
4 Dirt on the PCB-ASSY-ADJ1
sensor surface If soiled, clean the sensor surface with a soft cloth.
5 The connection of the
PCB-ASSY-ADJ1 harness
connectors Check that the harness connectors are properly connected
to the board connectors.
6 The PCB-ASSY-ADJ1 harness
condition - Check that the cables are not disconnected, caught in
order parts, and that the jackets are not damaged.
- Check that the AUTO ADJFFC,MW terminal is not
damaged.
- If a problem is found, replace the part.
7 PCB-ASSY-ADJ1 Replace the PCB-ASSY-ADJ1.
8 PCB-ASSY-HCB1M Replace the PCB-ASSY-HCB1M.
MANUALLY ADJUST nn
ADV VAL/PRINT POS
◎
nn
：
1 Calibration lower limit error
2 Calibration higher limit error
3 Adjustment value judgment error