Oilon RE 110, Installation And Operation Manual

Page: 30 / 52

28 (48) RE03 1406 EN
If the feature is sued, note following issues for locating remote control unit.
● Locate the remote control unit to the main living area.
● Choose the location so that sensor can measure room temperature as accurately
as possible. Place the remote control unit ideally on a light surface that does not
store heat or cold; a stone, brick, or concrete surface stays warm or cold for a long
time, and affects the temperature sensor measurements.
● Home electronics may cause disturbances in connection between remote control
and heat pump. Avoid locating remote control near home electronics.
● Make sure that the remote control unit is not exposed to direct sunlight or other
sources of heat or cold.
● Place the remote control unit ideally at about 1.5 m above floor level.
4.2. Changing settings
Whenever you change settings, always start from the basic display. See the following
image.
In case the basic display is not visible, press the back button as many times as
necessary until the display does not change any more. The display will revert back to
the basic display if nothing is done on the control panel for eight minutes.
The following procedure describes how to select menus and operating lines, and how
to change settings in the heat pump.
1. Press the
OK
button to access the menu system.
2. Select a menu item.
Use the settings knob to highlight a menu item.
3. Press the OK button.
A list of available operating lines in the selected menu is displayed on screen.
4. Select an operating line.
Use the settings knob to highlight a operating line.