Oerlikon CENTER TWO, Operating Manual

Page: 27 / 102

26
GA 09.035/6.02 - 07/2011 - © Oerlikon Leybold Vacuum
Operation
4.2 Switching on and off
4.2.1 Switching on
1 Switch the mains switch on. See Fig. 3-4, 18, item H.
After switching on, the Multi-Channel Controller will perform the following
actions:
„ Self test
„ Identify all transmitters
„ Restore the previously set parameters
„ Activate measurement mode
„ Adapt parameters (if a transmitter type has changed meanwhile)
4.2.2 Switching off
1 Switch the mains switch off. See Fig. 3-4, 18, item H.
4.2.3 Waiting time
Delay time.
After switching off, the Multi-Channel Controller requires approximately 10
seconds to initialize again.
Wait for at least 10 seconds before you switch the Multi-Channel Controller
on again.
Note:
If the Multi-Channel Controller has been installed in a control panel or a
rack, it can also be switched on and off via the central power distributor.
Caution