Installation
GA 09.035/6.02 - 07/2011 - © Oerlikon Leybold Vacuum
15
3
Installation
3.1
Unpacking
1
Visually inspect the transport packaging for signs of external damage
2
Unpack the Multi-Channel Controller and put the packaging material
aside
Note:
Keep the packaging material for later use. The Multi-Channel Controller
must be stored and transported in the original packaging material only.
3
Examine the Multi-Channel Controller for completeness
4
Visually inspect the Multi-Channel Controller for signs of damage
Damaged product.
Putting a damaged product into operation can be extremely dangerous.
Never attempt to put a damaged product into operation. Secure the dam-
aged product from unintended operation. Send a damage report to the
haulage company or the insurer.
3.2
Mechanical installation
The Multi-Channel Controller can be used as follows: As a desk-top unit,
mounted in a control panel, or mounted in a 19" rack. In each of these cases
you must pay attention to the following safety note:
Too high ambient temperature.
Exceeding the maximum permitted ambient temperature may damage the
unit.
Make sure that the maximum permitted ambient temperature is not ex-
ceeded and that the air can flow freely through the louvers. Do not expose
the unit to direct sunlight.
3.2.1
Desktop unit
In order to use the Multi-Channel Controller as a desk-top unit, proceed as fol-
lows:
1
Turn the Multi-Channel Controller upside down as shown in Fig. 3-1,
2
Push the supplied rubber strip onto the lower edge of the front panel
3
Stick the supplied rubber feet to the bottom of the casing
Warning
Caution
