TOYOTA
Reference
400CF
Procedure
Issue A 8/14/14
Page | 16
g.
Plug the Black 10-pin connector from the
Quick-Sync Harness into its designated
receptacle on the Sub Amplifier.
(Fig. 8-7)
h.
Carefully insert Amplifier Assembly through
the bottom opening underneath the diver-
side dash.
Note:
Tilt Amplifier Assembly to
position into designated mounting location.
Brackets and amp assembly are clearly
labeled "
A
" and "
B
".
(Fig. 8-8)
i.
Start by threading the Top "
A
" bracket with
provided wing nut and washer. Only partially
tighten "
A
" bracket mounting for the time
being. Position Lower "
B
" bracket into
position and tighten. Tighten "
A
" completely.
j.
Once the Amplifier installation is completed
under in kick panel area, secure any wire
slack to existing factory wiring. Use cable tie
as necessary.
(Fig. 8-9)
9.
Dash Speaker installation
a.
Using a pick or panel tool carefully lift dash
speaker grill up out of position.
(Fig. 9-1)
Fig. 8-7
Fig. 8-8
Fig. 8-9
Fig. 9-1
Pick Tool
* See Series 2 Connectivity Addendum
