TOYOTA
Reference
400CF
Procedure
Issue A 8/14/14
Page | 10
e.
With the factory speaker module in hand
disengage the locking tab on the bottom of
the module. Using a precision screwdriver or
pick tool,
gently
lift to unlock. Caution:
Locking tab only needs to be lifted slightly to
unlock the terminals of the factory
speaker module. Over prying the piece will
break the tab.
(Fig 5-5)
f.
Insert the terminals of your O+ rear speaker
bypass umbilical cable into the factory
speaker module. With the locking tab facing
down the orientation is as follows.
(Fig. 5-6)
1.
Under the factory grey and blue wires
you will insert the yellow and blue pins
from left to right.
2.
Under the newly inserted yellow and
blue wires; insert the red and black pins
from left to right. There will be a factory
blue and white striped wire in the terminal
below.
g.
After installing all the terminals and ensuring
that they're locked in place reinstall the
locking tab on the connector.
(Fig. 5-7)
h.
Locate and remove the 10mm ground bolt
located in the driver-side kick panel area.
(Moving factory wiring just left of the factory
speaker module to reveal the ground may
be necessary).
(Fig. 5-8)
Fig. 5-5
Pick Tool
Fig. 5-7
Fig. 5-6
Fig. 5-8
10mm Socket
