Octagon PC-500, User Manual

Page: 34 / 233

2-1
PC-500 user’s manual Quick start
Chapter 2:
Quick start
This chapter covers the basics of setting up a PC-500 system and tells you:
n
How to install and power on the PC-500 and run a demo program
n
How to use a serial console instead of the on-board SVGA video.
Follow the mounting procedures for the PC-500. To establish a serial
console link, go to the Serial console section in the Console devices chapter.
≡
Installing the PC-500
To install the PC-500 you will need the following equipment
(or equivalent):
n
PC-500 Mobile Industrial Computer
n
+5V power module
n
AT compatible keyboard with PS/2 connector
n
VGA monitor
n
VGA-12 cable
1. Refer to the PC-500 component diagram (Figure 2-1) for the location of
various connectors, before installing your PC-500 system.
WARNING!
The PC-500 Mobile Industrial Computer contains static sensi-
tive CMOS components. Do the following to avoid damaging
your card and its components:
n n
Ground yourself before handling the PC-500 card
n n
Disconnect power before removing or inserting a PC/104
expansion board
n n
When programming a memory device, place the device in
the socket before applying power.
Hardware components required to mount the PC-500 (not included):
n
8 threaded hex stainless steel standoffs (4-40 x 3/8")
n
8 screws (4-40 x 1/4")
n
8 internal star lock washers (4-40)
2. Use the #4 standoffs, washers, and screws and place them in the eight
holes on the PC-500 board. Refer to Figure 2-2 for the center-to-center
mounting hole dimensions and for the location of the designated holes used
for mounting the hardware.