OCEM AUGIER energy DIAM3100 Series, Installation & Maintenance

Page: 27 / 68

DIAM3100©2012 AUGIER SA.
I-27
Press OK to start initialisation.
The message “ Wait please...”
flashes meaning that data collection is in progress.
When the message stops flashing, data collection has been completed.
The number of fault lamps can be seen in the “
Monitoring”
menu
Two comparison levels (warnings level 1 & 2) are available. They are preferably fixed at 5 and 10.
Setting Level LFD1 and Level LFD2 parameters:
Go into the menu “ Alarms and Warnings” then “
Burnt Lamps Fault
”.
Remote back indication:
•
Each level reached is indicated by a dry contact output
•
The number of fault lamps, levels and warnings are transferred to the Jbus table.
•
To reset the stored values (for 0 and X lamp burned) during learning. Go in the menu “Calibration” then:
While press
ing ‘OK’, learning is reset and to determine the number of burnt lamps on the output load, it is
necessary to perform a new learning calibration (for 0 and X lamp burned).
I.7.6 WIG WAG
The CCR can operate in wig wag mode (LAHSO applications), activating the option flag in the “
Option”
menu.
In the menu
“
Wig Wag
”, it is possible to modify the “
WigWag tcycle
” and the "
WigWag ton ".
t cycle t on
B0
B1 .... B7