Oce PlotWave 900, User Manual

Page: 188 / 396

Define settings for the next original
Introduction
You can define the settings for each original you want to copy. When ‘Automatic feed’
is enabled, you should bear in mind that the original is automatically pulled into the
scanner. If you want to be absolutely sure about the settings that belong to an original,
insert an original when the settings are correct.
Note:
To increase your versatility at the scanner input side, you can ask your key operator to
turn off automatic feed. When using the scanner with automatic feed off, you must press
the start key for each new original to be scanned. This offers you the possibility to change
the settings for the next original, even if you already put the original in place on the
scanner feed table.
Define settings for the next copy job
1.
Select the “Preference” section.
2.
Press the ‘Rewind original’ function key to make your selection:
• If ‘Automatic feed’ is off, press the start key.
• If ‘Automatic feed’ is on, the original is fed automatically.
Chapter 6 - Use the Océ TDS600 scanner to copy 188
Define settings for the next original