Oce DJDE, Reference Manual

Page: 42 / 255

Summary of CODE Command Parameters Input Processing
34
A29247-X4-X-8-7672
2.3 Summary of CODE Command Parameters
A CODE command is referenced by the CODE or LCODE parameters of the VOLUME
command whenever a user-defined code translation table is required.
An identifier label (ac:) is optional for the first CODE command within a JDE. Thereafter,
each additional CODE command within the JDE must be labeled. Therefore, when multiple
CODE commands are available within a JDE or JDL, only one can be unlabeled. The syntax
is ac:CODE.
ASSIGN This parameter defines user code assignment exceptions, or the entire user char-
acter translation table.
DEFAULT This parameter specifies a base code from which code assignment exceptions can
be made. The base code is specified by a code-type; the exceptions are specified
using the ASSIGN parameter.
Parameter Definition(s) Offline Online DJDE
ASSIGN=
input ,
( out-put
1
[, output
2
]
[,...])
input
Defines the input code.
output
This parameter defines one or more entries to a code-
translation table.
Y Y N
DEFAULT=
code-type
The code type can be one of the following
EBCDIC
ASCII
This option defines the basic-volumes of a code-
translation table.
value
A value is a one-byte hexadecimal, octal, or alpha
constant. If a value is specified, all inputs are coded to
the specified
value .
The DEFAULT parameter must be coded prior to any
ASSIGN parameter for the assignment exceptions to
come into effect. A DEFAULT parameter following
any defined corresponding ASSIGN input or output
parameter options causes this correspondence to be
replaced by the DEFAULT parameter.
The default is EBCDIC.
Y Y N