Preparing the replacement cart
Caution:
Before each use, check the replacement cart for operational readiness. If you find serious
defects that could cause health hazards or material damage, the device must not be used.
Attention:
The replacement cart batteries should be recharged every night, or occasionally if the re-
placement cart is not in use for a longer period of time. The batteries cannot be overloaded.
Strictly observe the following safety directives when charging the batteries:
■
Never connect the battery charger to the hoisting lift only, as this results in the batteries
being discharged.
■
Do not heat batteries or put them into or close to a fire.
■
Keep batteries away from children.
■
Do not use special batteries with other devices.
■
Do not open or break batteries.
■
Always charge the battery packs through the charging socket in the housing.
■
Always use the original battery charger to recharge the batteries. It is equipped with
charge characteristic monitoring to ensure optimal recharging and a long battery life.
Use of a different battery charger may result in damage to the battery through power
surges, heat buildup or stray voltage.
■
Always dispose of batteries through the recycling system; do not dispose of them in
normal garbage.
To charge the batteries
#
Proceed as follows:
Connect the battery charger to the hoisting lift connection (18 V, 6.5 Ah).
1.
Connect the charger to the power socket.
The red and yellow LEDs light up.
2.
When the batteries are charged (the green and red LEDs light up):
■
Disconnect the battery charger from the power socket.
■
Disconnect the battery charger from the charging connection of the hoisting
lift.
3.
Chapter 6 - Operating the Printing System
169
Preparing the replacement cart
Summary of Contents for ColorStream
