![background image](http://html1.mh-extra.com/html/oce/blm-500/blm-500_operating-information-manual_722584083.webp)
83
Clear a Stitch Head Jam
[44]
Step
Action
Information
1
Lift the Booklet maker main
deck.
See
Lift the Booklet maker Main Deck
on page 41
2
Remove the wire-holder
from the stitch head.
■
Move the wire-holder retaining
spring to the right.
figure 42 on
page 81
■
Remove the wire-holder
If the wire-holder is held in position,
use a screwdriver to help remove the
wire-holder from the stitch head.
[44]
3
Inspect the area behind the
wire-holder for stitch-wire.
figure 43 on page 82
4
Remove any stitches or
pieces of stitch-wire and
clean the area with the air
duster.
Use wire cutters to remove any
jammed stitches or pieces of
stitch-wire.
5
Lubricate the stitch-head.
Lubricate the Stitch Head on
page 102
6
Fit the wire-holder.
Remember to put the wire-holder
retaining spring in position.
7
Close the Booklet maker.
8
Start the Booklet maker.
If the head operates normally and
returns to the parked position, then
further action is not needed.
If the stitch-head remains jammed,
then repeat the procedure again.
If the problem continues, contact
your service engineer.
Summary of Contents for BLM 500
