Oce BLM 500, Operating Information Manual

Page: 73 / 118

73
Clear Paper Jams
[34]
Step Action Information
1 Open the Booklet maker main
deck
2 Remove the trim bin.
3 Loosen the trimmer infeed
conveyor. The procedure can be seen from
the top of the machine. Access to
the parts is through the
former-clamp mechanism. Hold
the shaft and push to the right,
against the spring pressure.
Hold the shaft and push to the
right, against the spring pressure to
disengage the shaft from the drive
pin.
[36]
Lift the left-hand end clear.
4 Remove the book, if one is
found.
5 Remove any paper offcuts
from the trimmer infeed
conveyor. A small piece of paper can cover
the jam sensor and cause an error
message.
6 Install the trimmer infeed
conveyor. Insert the right-hand end of the
shaft into the bearing, against the
spring pressure. Insert the
left-hand end.
7 Install the trim bin.
8 Close the Booklet maker main
deck and covers.
9 If there is paper in the
gathering area, touch START,
then touch ADVANCED >
PURGE SET > PURGE
SET. This action clears paper from the
Booklet maker.
10 Continue the print job.