Oce 9400-I, User Manual

Page: 76 / 159

76 Océ 9400-II User Manual
Introduction
The Océ 9400-II can also be used to digitize analog drawings and upload them
to a host computer over a SCSI-2 interface. The Scan-to-file option is used fo
this purpose.
This option consists of the following components:
■
Océ Scan Station software
■
Océ View Station software
■
SCSI-2 board (option) in the PC to connect to the Océ 9400-I
■
SCSI-2 cable (option)
▼
▼ ▼
▼
Making upload
After everything has been installed correctly on the Océ 9400-II and on the PC,
both systems must be connected with a SCSI-2 cable before uploads can take
place. See ‘SCSI-2’ on page 2 5 .
1
Turn on the Océ 9400-II and the PC.
2
Start the Upload application, set all scan parameters as required, and then
proceed as described below. (See also the Océ 9400 Series Scan Station
manual).
As soon as the upload is started with the application, the Océ 9400-II printer
panel displays “SCANMODE”, signifying that the system is ready to perform
uploads.
3
Insert an original in the scanner, specify the required settings on the scanner's
operating panel and press the Start button on the scanner (see also the notes
below).
4
Once the original has been scanned and transported back to its start position, a
checkplot may be performed. In order for a checkplot to take place, the
corresponding option should have been selected in the Scan Station
application. The checkplot is created on the media selected on the scanner's
operating panel.
5
At this point, the Océ 9400-II controller creates a file which will be uploaded
to the PC.
Once the file has been uploaded, it can be viewed on the PC.
6
Settings can be modified on the PC or on the scanner and a subsequent original
can be scanned, or the current original can be re-scanned with the new settings.
7
The upload process can be halted on the PC, thus freeing the Océ 9400 series
for print and/or copy jobs. (See also the Océ 9400 series Scan Station manual).