Oce 9400-I, User Manual

Page: 141 / 159

Controller firmware upgrade 141
4
Open a terminal session on your host (e.g. WINDOWS terminal) with the
following settings:
5
Turn the printer on.
6
You will be prompted to press the CTRL-P key with the following message:
“Press CTRL-P to update the application / fls/EPC-M1........”
You have 5 seconds to press this key, otherwise the controller will not update
the firmware.
7
When CTRL-P is pressed, you are prompted to confirm your choice.
“You have pressed CTRL-P key”
“Do you confirm to update the file application /fls/EPC-M1?”
“Y confirm / N cancel”
8
If you press N, the controller will start with its current firmware version.
9
If you press Y, you are prompted to send the new firmware file through the
Centronics port:
“Transfer controller software through the Centronics port”.
10
Send the new firmware file from your host, e.g. on a DOS session on a PC:
copy /b EPC-M1_1.0.ld lpt1
11
The following messages allow you to monitor the progress on the terminal
window:
“Loading file”
“Transfer progress xx%”
‘Transfer successful, checksum 0x........”
“Writing to Flash”
“Erase Flash ...... done”
“Writing progress: xx%”
“Done”
“Operation Complete”
“Transfer successful”
“Turn machine OFF then ON to apply modifications”
12
Turn the printer off.
baud rate
9600
data b
8
stop b
1
parity
none
flow control
none