Oce 3121, Technical & Service Manual

Page: 816 / 908

4 TSM Océ 3121 SDS Description
Using Adjustment Mode and Settings Mode
In adjustment mode (*3*; ADJUST) and in settings mode (*5*; OPTION), the
settings changed/selected on the control panel are stored in RAM on the image
processor PCB and operation/control is executed according to the settings.
(These settings will be stored permanently when the main power switch is
turned off and on after execution.
The factory default settings of adjustment mode (*3*; ADJUST) are recorded
in the service-label. Be sure to record any new settings if you made changes in
the field. Further, you must enter the settings recorded on the label whenever
you have cleared the RAM.
If you replaced the image processor PCB or the composite power supply PCB,
be sure to enter the settings recorded on the respective label. (You need not do
so when you have replaced only the ROM.)
Service Label; attached behind the front door
MF-A6R DVLP DC OFST FILM LANK
MF-A4R H-ADJ ABC_TBL
MF-A4 V-ADJ STRD_ADJ
PRI DC (IMG) REGIST PPR
PRI DC(on IMG) RSIDE-SENSHP W-PLT
DVLP DC (IMG) PVE-OFST TRNS_1
DVLP DC (on
IMG) IC-DENS TRNS_2TS
TRNS (IMG) CST-LOOP TRNS_2OL
TRNS(on IMG) MF-LOOP
PRI AC (IMG) DENS-ADJ
PRI AC(no IMG) ADJ-S
AGS GAIN LASER OFF
AGS OFST PWN 600 MIN
PRI DC OFST PWN 600 MAX
PRI AC OFST1 PWN 200 MIN
PRI AC OFST2 PWN 200 MAX
TRNS OFST AE-SLOP
FL OFST FIXER_RESIST