Oce 3121, Technical & Service Manual

Page: 100 / 908

C
o
nf
id
en
ti
a
l ©
19
98
O
c
é
-T
ec
hn
ol
o
g
ie
s
B
.V
.
ed.1 Image quality 27
A, B and D are approximate values. Optimum images may still be obtained
even if the values are outside the range. You may omit ‘ temporary remedy ‘ if
the images are optimum.
■
For PD and 200 PWM
20 <= A <= 50
-40 <= B <= 40
0 <= D <= 8
■
For 600 PWM
20 <= A <= 60
-70 <= B 20
0 <= D <= 8
20
Check the above and press ‘ DATA SET “. It will highlight.
Then, press ‘OK’.
■
This will set the measured values under A, B and D.
21
Press ‘ Page ‘ and execute ‘ 200 PWM: density automatic adjustment ‘ . Fol-
low the same steps, starting with step 9.
22
When ‘ 200 PWM density automatic adjustment ’ is finished, execute ‘ 600
PWM density automatic adjustment’. Follow the same steps, starting with
step 9.
23
Press ‘ Reset ‘ twice, ending the service mode. If the values for A, B and D do
not match, after repeated execution of ‘ copy density automatic correction ‘,
and it proves to be impossible to obtain optimum images, the follow temporary
remedy can be used. The temporary remedy will enable normal copying. How-
ever, as the image quality is inferior, correct the faults as soon as possible.
Then, execute ‘ copy density automatic correction ‘ .
Possible fault
■
OPC unit
■
Scanning lamp
■
Laser unit
■
Power supply PBA
■
Analogue processor PBA
■
Image processor PBA