Oce 3121, Technical & Service Manual

Page: 172 / 908

64 TSM Océ 3121/3122 FAX related error codes
.
##220 (reception/transmission) A system error has occurred. (The main pro-
gramme has run incorrectly.)
Main cause Action
■
The CPU has malfunctioned, because of
noise.
■
Switch OFF, then ON.
##224 (trans/recep) An error has occurred in the protocol signal, in G3 communica-
tion mode.
Main cause Action
■
There is an error in the protocol signal.
■
Record the communication procedure
sound on DAT, for analysis by a technical
centre.
##232 (trans) The unit for ENCODE control has malfunctioned.
Main cause Action
■
The UPI operation for ENCODE control did
not end normally.
■
Replace the unit (e.g., system control PBA)
for ENCODE control.
##237 (recep) The UPI for DECOE control has malfunctioned
Main cause Action
■
The UPI operation for DECODE control did
not end normally.
■
Replace the unit (e.g., system control PBA)
for DECODE control.
##238 (recep) The unit for PRINT control has malfunctioned
Main cause Action
■
The UPI operation for PRINT control did
not end normally.
■
Replace the unit (e.g., system control PBA)
for PRINT control.
##261 (trans/recep) A system error has occurred in the modem, or the gate array.
Main cause Action
■
The internal unit has a fault. When RS is set
to 1, CS will not change to 1.
■
Replace the modem PBA.
■
Replace the system control PBA.