Objet Connex500, Operating & Maintenance Manual

Page: 10 / 68

Operating & Maintaining the Connex500/350 3-D Printer
7–10
DOC-13000 Rev. E
If you cannot continue printing:
1. Cancel the print job in Job Manager.
2. Remove the partially printed model from the build tray.
3. Send the job to the Connex printer again.
Changing the Model Material
Before producing models using a different type of model material than is
currently installed, run the Material Replacement wizard to flush the print
block and feed tubes.
To replace the model material:
1. Start the Material Replacement wizard from the Options menu.
Figure 7-8: Starting the Material Replacement wizard from the Options menu
2. In the opening screen, click
Next
.
3. If the printer cover is not closed, a screen appears instructing you to
close the cover. Confirm that it is closed and click
Next
.
You can stop and later resume printing from either the Connex printer
interface or the Job Manager interface, since both applications are updated
when you use these commands. However, after clicking the
Pause button in
the printer interface, you can only resume printing from the printer interface.
You should carefully plan printing models with different model materials to
avoid unnecessary waste of the material loaded in the printer. The amount
of material flushed depends on the flushing cycle chosen and if you are
replacing one or both cartridges.
All manuals and user guides at all-guides.com