MI9601-00 • Issue C • May 2001 • Section 2: NV9601 Installation
Page 2-6
Legend Installation Procedure
Install the key cap legends into the button caps as follows. No tools are required.
Installing the legends with the panel on a table or work bench is easier than trying to do
it with the panel in an equipment rack.
1. Decide which of the supplied legends you want to use and on which buttons you
want to install them (other than the dedicated ones shown in
Figure 2-2
). Note the
chosen legend locations using the template on the next page (
Figure 2-4
).
2. Place the mylar legends and the legend location template on a flat surface near
your work area where you can read them.
3. Position the NV9601 front panel for easy access to the key caps and legends.
4. Remove the key caps from the front panel by gently prying up on the side of each
cap with your fingers. Put the key caps on the work surface.
5. Place a legend into each key cap and assemble the key caps onto the push buttons
in the panel as shown in
Figure 2-3
. Be sure to place the correct legends on
dedicated push buttons, such as the Take button and the numerical keypad buttons,
as shown in
Figure 2-4
.
Figure 2-3. Key Cap Legend Installation
Caution: Be sure to adequately support the Control Panel while installing
the key cap legends so as to prevent damage to the panel or its connectors.
q
Note: Ensure the legend is placed so as to be legible once the key cap is installed. Some
buttons may have two legends, such as numeric keypad buttons that also serve as function
or category buttons.
Clear
Key
Cap
Legend
Push
Button
