Nuova Simonelli TALENTO, User Handbook Manual

Page: 61 / 192

Fig. 25
Fig. 26
Fig. 27
59
EN
9. CLEANING AND
MAINTENANCE
Before carrying out any cleaning operations, set the
machine to the “ O ” energy level, (machine switched
off and plug removed from the mains).
Never use solvents, chlorine-based products,
abrasives.
WARNING
Cleaning the work area : slide out the work top and
remove the drip tray; clean all with hot water and
detergent.
Cleaning the external surfaces: To clean the pan-
els, use a soft, damp cloth.
9.1 CLEANING THE
OUTSIDE OF THE
MACHINE
NOTE : Follow the instructions on the label applied on
the inside of the front door.
9.2 CLEANING THE
DELIVERY UNIT AND
THE MILK FOAMER
The machine is equipped to wash the delivery unit
with detergent tablets and the milk circuit with liquid
cleansers.
The machine will begin a wash cycle that consists
of hot water deliveries alternated with pauses. The
whole cycle lasts approximately 4 minutes.
We recommend that you carry out a WASHING
CYCLE at least once a day using special cleans-
ers.
CAUTION
RISK OF INTOXICATION.
We remind you not to interrupt a washing cycle
using detergent tablets once started, other-
wise detergent residues may remain inside the
machine.
In order to execute the washing procedure proceed
as follows:
1. Place a container with 1 litre of water alongside
the machine.
2. Put the suction tube inside it.
3. Add the specific cleaning product (20 ml [0.005
Gal] of Puly Milk ).
NEVER use water jets to clean the machine.
WARNING
During maintenance/repairs, the parts used must be
able to guarantee compliance with the safety and
hygiene requirements envisaged for the device.
Original replacement parts can offer this guarantee.
After repairs to/replacement of a part that comes
into contact with foods or water, it is necessary to
carry out a washing procedure or to follow the steps
indicated by the manufacturer.