Nuova Simonelli TALENTO, User Handbook Manual

Page: 47 / 192

Fig. 17
45
EN
The water hardness must be less then 4° - 6° fr
(french degree).
The chlorine content must not exceed 100mg per
litre (0.00000361lb/cu in).
Otherwise the conditions of guarantee of the
machine will expire.
WARNING
The machine must be installed according
to the local standards in force with regard
to plumbing systems. For this reason, the
plumbing connections must be carried
out by a qualified technician.
1 Remove the cap to access the granulated coffee
bean container.
WARNING
4.2 FILLING THE COFFEE
CONTAINER
2 Don’t fill to the brim but pour just enough toasted
coffee beans into the coffee bean holder to
ensure correct closure of the unit.
3 Close the cap.

Pour ONLY toasted coffee beans into the coffee
bean holder. any other kind of coffee, for example
ground coffee, will damage the coffee grinder.
Don’t insert caramelized, sugar coated, or simi-
larly coated coffee beans, or instant coffee or
other sugary beverages because they will harm
the appliance.
NOTE: in case the following procedure shouldn’t
take effect, see the chapter on “Problems
and Solutions”.
4.3 SWITCHING ON
WARNING
WHEN INSTALLING FOR THE FIRST TIME
OR STARTING THE MACHINE AGAIN AFTER
BOILER TANK GROUP SERVICING, BEFORE
SWITCHING ON THE MACHINE AND STARTING
THE HEATING PROCESS, BE SURE TO FILL THE
COFFEE BOILER TANK, (PAGE 57 PARAGRAPH
8.3) UNTIL THERE IS A REGULAR FLOW FROM
THE WAND.
4.4 SWITCHING OFF
To switch off the machine, proceed as follows:
• Press the ON/OFF key .
After the preliminary operations:
Press the ON/OFF key.
PLEASE wAIT
after the heating phase, the display will read: and the
machine will be ready for use.
The heating stage takes approx, 5 minutes.
NOTE : The appliance is endowed with a security
system that will stop the machine after about
1.5 minutes of constant functioning of the
pump (to avoid pump overheating). In this
case, switch off the main switch of the
machine and then turn it on again.
The machine is now ready to be used.
SELECT PRODUCT
The machine will carry out a group positioning cycle;
this is the cycle for filling the boiler with water at the
end of which, if the machine is cold, there will be a
heating cycle and the display will read: