DSP LASER AP with MCS
3. Insert the new tool, in this example shortest, according the direction of arrow B (Figure
71).
Figure 71
4. Bring TX back in position according to the direction of arrow A (Figure 72)
5. Put the TEST instrument on point B (Figure 72).
6. Set a reduced closing speed (less than or equal to 10 mm/sec) and lower the tool until
when its tip brushes the vertex of the groove present in the notch in the top part of the
TEST instrument.
Figure 72
92
DLAM01EN
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
