DSP LASER AP with MCS
5.
Safety precautions
5.1.
Checks
•
Check the operating voltage of the device before use.
The operating voltage (24Vcc ± 10%) is indicated on the plate located on MCS module.
The device is not disconnected from mains until MCS module is physically connected to
the electric panel, even if the device seems “off”.
•
Stop immediately using the device in case of penetration of liquids or objects
inside the device itself.
Disconnect the device and take care that qualified personnel checks it.
To disconnect the device, refer to the procedure described in the chapter relevant to the
device removal.
5.2.
Spare parts
Spare parts can be supplied only by Nuova Elettronica.
5.3.
Decommissioning
If You decide to stop using DSP LASER
AP and MCS device because obsolete or
irremediable faulty, decommission it making the device itself not operating and deprived of
risks. Seal the device within a robust package and dismantle it acting in compliance with the
current laws in force, contacting the local bodies charged for these operations.
4
DLAM01EN
Summary of Contents for DSP LASER AP
Page 2: ......
Page 4: ......
Page 50: ...DSP LASER AP with MCS Figure 34 44 DLAM01EN...
