Nugen S10KS, Operator'S Maintenance Manual

Page: 54 / 64

OPERATOR & MAINTENANCE MANUAL
PAGE ‐ 50
supply power.
NOTE: Before operating the automatic start ‐ up mode, connection of ATS is required.
5.5 During Operation

Check the LCD reading of voltage, current, frequency by scrolling the Display
Buttons ↑ and ↓ .

Check the LCD reading of engine oil, coolant and fuel levels.

Check the LCD reading of engine oil pressure and coolant temperature.

Check for any alarm signal on the LCD or audible alarm.

Check for any leakage of coolant, oil or fuel.

Check for any unusual vibration or noise.

Check for any unusual colour from the exhaust. Under normal conditions the
exhaust gas has no colour.

If the engine cannot run because of low fuel, bleed the air
from the fuel system.

Loosen air release bleed bolt on the fuel filter.

Bleed the air in the fuel system for about 30
seconds.

Tighten the bolt.
CAUTION:
1. If a fault is detected, stop and isolate the machine immediately.
2. Generator to be repaired by certified or fully trained personnel (refer to
troubleshooting guidelines 6.7).