Nugen S10KS, Operator'S Maintenance Manual

Page: 50 / 64

OPERATOR & MAINTENANCE MANUAL
PAGE ‐ 46
5. Operation
5.1 General Pre ‐ check Before Starting
Before starting the generator, check each item below:

Check engine oil, fuel and coolant.

Check for leakage at the hose connections.

Check to make sure there are no obstructions lodged in vents, near the radiator or
around the cooling fan.

Ensure that nothing is contacting the muffler or exhaust pipes.

Check the generator is earthed and the earth spike is installed and tested as per
local regulations.

Make correct terminal connections. TEST accordingly.

Check that all electrical connections were made in compliance with local regulations
and standards.

Make sure the fan belt and hoses on the engine have no loose connections or are
fraying. Tighten or replace as required.

Check the battery cables are firmly secured to the terminals. Tighten the clamps if
necessary.

Close and secure side panel access doors.

Review and follow safety instructions at the front of this manual.
Warning:
1. Failure to follow the procedures listed in this manual may cause injury to personnel or
damage to the generator. Ensure all persons setting up the generator are certified or
fully trained on the installation of the generator.
2. Always wear protective gloves, clothes and other P.P.E. as required.
WARNING:
Do not use the machine when any leak is found. Repairs are only to be carried out
by trained personnel and according to regulations.