Nugen S10KS, Operator'S Maintenance Manual

Page: 34 / 64

OPERATOR & MAINTENANCE MANUAL
PAGE ‐ 30
WARNING:
ONLY press emergency stop button in the case of an actual emergency.
Note: Stopping the generator under load may cause mechanical damage!
10 & 11. General Purpose Outlets (GPO) (15A, single ‐ phase)
The generator is equipped with two Auto switched 240V single ‐ phase GPOs
(10) & (11) rated at 15A. Both are connected through the Main Isolator. Each
GPO is protected by it’s own RCD/MCB combo breakers located in the
control cabinet.
12. Emergency Stop Switch
The generator is equipped with two red emergency stop switches. One switch
(15) is located in the field wiring cabinet, the second is adjacent to the control
cabinet. The two switches are wired in series. When activated, the emergency
stop (activated by pushing the red button) will turn off the fuel solenoid,
resulting in the engine shutting down. Rotate button to reset emergency stop.
Note: The cabinet emergency stop has a protective cover, which has to be
lifted to be activated.
13. Mains Inlet for Battery Charging (10A male 3 flat pin, single phase)
The generator is equipped with one 240V single phase 3 flat pin inlet, (13)
rated at 10A. It connects to the battery charger through an RCD/MCB combo
breaker, which is located in the control box.
14. General Purpose Outlet (GPO) (Manually switched 20A, single ‐ phase)
The generator is equipped with one 240V single ‐ phase GPO (14) rated at
20A. The GPO connects through the Main Isolator. It is protected by its own
RCD/MCB combo breaker located in the control cabinet.