![background image](http://html1.mh-extra.com/html/nu-flame/synergy-ellesse/synergy-ellesse_use-installation-and-servicing-instructions_1715506025.webp)
25
n.
Firstly, carefully place the remainder of the natural coloured
vermiculite granules (from the large bag) around the bark chips
and logs so that none of the fuel tray is visible.
Secondly, sprinkle the reminder of the black vermiculite granules
(from the small bag) over the same area.
Ensure that any Vermiculite granules that fall onto the ported
(holes) area of the Burner are removed.
Important: Check that No Vermiculite Granules or Bark Chips are on the ported (holes) area around the burner.
o.
Remove the Emberglow from the packet provided and now thin out the strands of material. Working between the logs place
strands on top of the Vermiculite on the central Burner area. Placing the material between the logs will allow the flames to make
the material glow.
p.
Before sealing the glass outer door with the 2 screws and the Pozidriv screwdriver provided, check the condition of the glass and
ensure it is clean and free from any finger marks. If the fire also has an outer glass door repeat the procedure.
Note :
The Emberglow material is a consumable material and as a limited life. You can buy replacements through your local
Nu-Flame Ltd Stockist or Installer.
q. For Synergy Perspective Glass - Wall Mounted Installations Only
Fitting the Glass Shelf (The Glass Shelf Will Have to be Fitted prior to Testing Commissioning & Use)
Fit the Glass Shelf by first locating the outer 2 holes over the Rivet Stems at the left and right corners of the Case and fixing with
the 2 screws provided, see diagram. The Outer Door is fitted later.
18. TESTING, COMMISSIONING & USE
Important
: During its first period of use any protective coatings and oils will burn out of the fire and it is wise to ventilate the
room for the first hour; also advise the customer that this may persist for the first few days until the fire is fully burnt-in.
18.1 - LIGHTING THE FIRE
a.
Reference to Section 2 in the Users Instructions ’Lighting & Controlling the Fire’ will show how to light and operate the fire.
b.
Check that the supply pressure to the fire is at the pressures required, 20mbar (Natural Gas G20) or 37mbar (Propane G31) when
set at high.
IMPORTANT:
Ensure that the pressure test point used is sealed and gas tight.
Rivet Stems
Case see Rivet Stems
2 Screws
Glass Shelf