9
For driving under constant amplitude mode
(
Please purchase vibration sensor separately, that is an option part.)
1. Connection of input-output
Connect the parts feeder used
and input-output signal cable
etc.
5. Frequency adjustment
Frequency is adjusted so that
the amplitude of parts feeder
is appropriate.
Flow for driving
（
Constant amplitude mode
）
3. Setting of functions
Functions are set to match
your using conditions.
4. Driving
Driving signal is input to start
driving.
＜
Basic connection
＞
・
Connection of power source
→
P.12
・
Connection of load cable (parts feeder)
→
P.13
＜
Connection based on using conditions
＞
・
External control input
→
P.16
～
P.17
・
Connection of sensor or valve etc.
→
P.18
～
P.19
Refer to P.10 onward
5. Speed (Voltage) adjustment
Voltage is adjusted with the
speed adjustment knob so
that appropriate amplitude is
output.
＜
Setting of function (J group)
＞
・
Setting of current rating J01 etc.
＜
Setting of data (H group)
＞
・
Sensor input logic
H00 etc.
In case that driving signal was input by your
company, start driving.
2. Connection of vibration sensor
Please purchase vibration
sensor separately.
＜
Installation of vibration sensor
＞
・
Installation of vibration sensor on parts feeder
→
P.14
＜
Wiring of vibration sensor
＞
・
Connection of connector to controller
→
P.15
6. Calibration
Implementation of calibration
Calibration is conducted with the
function key J05 to determine gain.
Refer to P.14 onward
Refer to P.34 onward
Refer to P.25
Refer to P.26
Driving frequency is
adjusted manually to
appropriate range.
適正範囲
振
幅
低
周波数(Hz)
高
共振点
Resonance point
Frequency (Hz)
Low
High
Amplitude
Appropriate range
Refer to P.28
Refer to P.31
Avoid here
Setting mark
Amplitude (Voltage)
increases by turning the
speed adjustment nob
clockwise.