22
(10) Mounting of terminal cover
Please check whether there is a mistake in the
connection of wiring.
Content to be checked
A)
Isn’t there any mistake in the connection
destination?
B) Isn’t there any mistake in the polarity?
C) Isn't there possibility of short-circuit and earth fault?
D) Is the earth surely connected? Was the protection
continuity test executed?
①
Guide is attached to the side of terminal cover. Try to
slide the upper edge into the deep side of panel from
bottom, trying to get the guide inside of the controller side
face.
②
Fix the cover with screw, supporting the cover not to fall
down.
In case of the electric screw driver, use under the torque
of 0.7N
･
m or less. Over tightening may cause damage to
screw. Moreover, take enough care for handling to avoid
such as impact and dropping.
Then the wiring work is completed.
ガイド板
左右２枚
Terminal cover
Guide plate
Two for right and
left
Ｍ３ビス ２本
はめる
端子部カバー
Make it to get
into deep
Terminal cover
Fit.
Two M3 machine screws