NorthStar MX500, Operator'S & Installation Manual

Page: 53 / 284

Version 3.0 39
Route Operator’s Manual
Insert By Number
The following example assumes RTE1 is empty. Follow the direc-
tions in the Erasing an Existing Route section to start with an empty
route if you have waypoints in the RTE1 screen.
1. Select the RTE key until the RTE1 screen is displayed.
2. Press the EDIT key to enter the edit mode.
3. Highlight the Insert softkey from the display and press the ENT
key. Skip to the next step if RTE1 is empty.
4. Highlight Insert by Number softkey from the display and press
the ENT key.
5. Use the EDIT keypad to type in the number you want or the be-
ginning number of a range you would like to select from, or use
the cursor key to scroll through the previously stored waypoints
in numerical order.
6. When you have found the waypoint you want, highlight the In-
sert this WPT softkey and press ENT .
7. You can then choose to select another waypoint using the same
method, highlight Escape and press ENT to go back one level
and use another method to enter waypoints, or highlight Done
and press ENT to go back to the main menu.
8. Don’t forget to press the EDIT key to end your editing.