Northern Lights OWN-ADV, Installation And User Manual

Page: 68 / 91

OWN-ADV 01/12
10.1 NORTHERN LIGHTS PROPRIETARY (FAST PACKET)
66
Start Position (Byte) Data Length Parameter Name Description
9 1 byte Genset controller
failure code 18 Loss Of ECM (Failure)
19 EPS Supplying Load (Failure)
20 User Text 1 (Failure)
21 User Text 2 (Failure)
0 No Failure
10 2 bytes Trip Running Time Generator run time since last start.
Resets to zero when generator stopped
Resolution 1 bit = 6 minutes
12 1 byte Genset Controller
Parameters Setting Bit0~1: AC Voltage
0 = AC not ready
1 = Single Phase 1 Wire
2 = Single Phase 2 Wire
3 = 3 Phases
Bit 2~3: Engine Temperature
3 = Sender
2,1 = Switch
0 = Not Available
Bit4~5: Fuel Level
3 = Sender
2,1 = Switch
0 = Not Available
Bit6~7: Oil Pressure
3 = Sender
2,1 = Switch
0 = Not Available
Bit8~15: (Reserved)
14 4 bytes Genset Controller
LED Status bit0: Over Crank Failure (red)
bit1: Over Crank Warning (amber)
bit2: High Engine Temp Failure (red)
bit3: High Engine Temp Warning (amber)
bit4: Low Oil Pressure Failure (red)
bit5: Low Oil Pressure Warning (amber)
bit6: Engine Over Speed Failure (red)
bit7: Engine Over Speed Warning (amber)
bit8: Low Fuel Level Failure (red)
bit9: Low Fuel Level Warning (amber)
bit10: Low Battery Warning (amber)
bit11: Battery OK (solid green in OFF
and RUN modes,
fl ashing green in AUTO
mode)
bit12: Not In Auto (red)
bit13: Not Used
bit14: Low Coolant Level Shutdown (red)
bit15: Low Coolant Level Warning (amber)
bit16: EPS Supplying Load Shutdown (red)
bit17: EPS Supplying Load Warning (amber)
bit18: not used
UPDATED 6/24/11