©2005 Nordic ID Oy
Nordic ID PL3000 user manual, v. 2.4, March 2006
13
2.2.2 Installing battery
The battery is located in the compartment inside the PL3000 handle. Open the compartment by loosing the
screw at the bottom of the device and lifting off the back cover. Place the bottom end of the battery to the
bottom end of the battery compartment, as depicted in figure 8. Push it against the battery support foam
so that the connectors in the battery face the connectors in the device. Push the top end of the battery into
the compartment.
If you are using handstrap, note that it is easier to slip the strap under the holding bar when the battery cover
is not closed. Close the battery cover and tighten the screw. If the battery cover is not properly closed the
device looses the IP 54 rating.
Fig.8 Installing battery
Fig.5 Open the slot cover
Fig.6 Install the SD/MMC card
Fig.7 Close the slot cover