©2005 Nordic ID Oy
Nordic ID PL3000 user manual, v. 2.4, March 2006
12
it has been left in cold temperatures for a prolonged time, allow sufficient time for the items to warm up and
reach normal room temperature and humidity before taking it into use.
2.2
Preparing the device
The battery in the device is normally fully discharged and must be charged for the first time for 8 hours prior
to using the PL3000.
2.2.1
Installing SD/MMC memory card
The SD/MMC card slot is located inside the battery compartment. The SD card cannot be installed when
battery is in place.
Open the SD/MMC card slot cover by lifting up the cover and removing the battery. Insert the SD/MMC card
so that the copper connectors of the card face down towards the front of the unit. Ensure that the cut corner
of the SD/MMC card is facing the upper right corner. Press the card into the slot until it clicks and the card
locks into place. You can remove the card by pressing it lightly to release the card lock. A spring in the slot
will push the card out of the slot. Close the SD/MMC card slot and replace the battery.
Fig.3 Taking the back cover off
1. Open the screw
2. Lift the
back cover
Use stylus as
a screwdriver
Fig.4 Removing the battery