Nordco Trailblazer BC60, Operation And Maintenance Manual

Page: 68 / 72

TROUBLESHOOTING
BC 60 "Trailblazer" Brushcutter
Section 4-4
AUGUST/2012 (49458202/8203)
PROBLEM POSSIBLE CAUSE SOLUTION
Battery uses too
much water
Cracked Battery
Case
Frozen battery
Keep battery fully charged in cold
weather. Replace battery.
Low Battery Output Low water level. Add distilled water.
Dirty or wet battery top causing
discharge. Clean and wipe dry battery top.
Corroded or loose battery cables Clean and tighten battery cables.
Broken Battery post.
Wiggle battery post by hand. If post
wiggles or turns, replace battery.
Wrong size replacement battery. Replace battery with type specified
under "Machine Specifications".
Starting Motor will
not turn.
Battery disconnect switch turned off. Turn switch to "ON" position
Defective ignition switch Repair or replace.
Directional Control not set to Neutral Lift control handle up to unlock and
move to Neutral position.
Bad solenoid Replace solenoid
Implement Pump Switch ON Turn switch to OFF position
Corroded battery terminals.. Inspect and clean if necessary
Air Horn does not
sound Air pressure low
Horn circuit breaker tripped Reset circuit breaker
Horn defective Check horn, repair or replace
Horn relay defective Check relay
Horn switch defective Check switch, repair or replace
Backup Alarm does
not sound Connection at alarm loose Tighten connection
Wiring harness defective Check harness, repair or replace
Alarm circuit breaker tripped Reset circuit breaker
Alarm defective Check alarm, repair or replace
Alarm relay defective Check relay
Alarm switch defective Check switch, repair or replace
Travel lights do not
work Wiring harness defective Check harness, repair or replace
Connection at light loose Tighten connection
Circuit breaker tripped Reset circuit breaker
Switch defective Check switch, repair or replace
Connection at switch loose Tighten connection
Light defective Replace light
Connection at circuit breaker panel
loose Tighten connection
Work lights do not
work Wiring harness defective Check harness, repair or replace
Connection at light loose Tighten connection
Circuit breaker tripped Reset circuit breaker
Switch defective Check switch, repair or replace
Connection at switch loose Tighten connection
Light defective Replace light
Connection at circuit breaker panel
loose Tighten connection
Cooling Fan not Loose connection at back of fan Tighten connection