PRE-OPERATION
BC 60 "Trailblazer" Brushcutter
Section 2-2
DEC/2012 (49458202/8203)
CUTTER HEAD – SAW-BLADE TYPE
The cutterhead consists of either a single
disk or dual disks (front and rear), each with
teeth and facebits. The Teeth are used for
cutting through dense trees and bushes. The
face bits pulverize the vegetation.
The teeth on the saw-blade type cutterhead
are razor sharp and care should be taken
when working on or in proximity to these
cutterheads.
ENGINE
Your machine is equipped with an automatic
shutdown system when low engine oil
pressure and high engine coolant
temperatures have been reached. Nefore
the machine reaches it's shutdown levels, it
will activate an audio and visual alarm.
Your machine is also equipped with a
shutdown override system, which will allow
you to override a shutdown in the event of an
emergency. This will give you time to move
the machine to a different location before
shutting down the machine and attempting to
troubleshoot the engine problems. USE
THIS SWITCH ONLY IN THE EVENT OF AN
EMERGENCY!
ELECTRICAL SYSTEM
The hydraulic functions of the machine are controlled by
the electrical system. The relays, limit switches, micro
switches and timing module that make up the electrical
system are shown on the schematics and wiring
diagrams included in the
ELECTRICAL section
of this
manual.
CONTROLS AND INSTRUMENTS
Some controls and all of the instruments are located on
the Main Control Panel (Logic Box). Additional controls
are located remotely on the machine. Become
thoroughly familiar with the function and operation of all
controls, as described in this section, before attempting
to operate the machine. However, the information in
this section is intended to be for descriptive purposes
only. Also read carefully the instructions in the
Operation
section of this manual
before
attempting to
operate the machine.
NOTE
:
Your machine may not have all the optional controls
and instruments that are described in this section.
Figure 2. Dual Cutter Head Overview
Summary of Contents for Trailblazer BC60
Page 2: ......
Page 48: ...BC 60 Trailblazer Brushcutter MAINTENANCE AUGUST 2012 49458202 8203 Section 3 3...
Page 49: ...MAINTENANCE BC 60 Trailblazer Brushcutter Section 3 4 AUGUST 2012 49458202 8203...
Page 64: ...BC 60 Trailblazer Brushcutter MAINTENANCE MARCH 2011 49458201 Section 3 21 TORQUE REQUIREMENTS...
