NorAM 65E Turbo, Service Manual

Page: 419 / 613

65E Turbo Motor Grader
Service Manual
Service 1.00_2006.03
Section 5
Rear Axle and Tandems
5-59
Step 42: Install shim pack, 1, selected in step 14, and
apply Loctite to outside surface.
Step 43: Apply Loctite to threads of cap screws, 2, Install
washers, 3, over cap screws, 2, and install through hub
with cap screw threads facing out.
Step 44: Hook up lifting device to tandem and lift tandem
into position at rear axle.
Step 45: Start cap screws, 2, and then torque cap screws
to 95 ± 5 Ib-ft (128.8 ± 6.7 Nm).
Step 46: Check tandem oscillation at this time by
attaching the oscillation jig, 2, (part number 73161824)
with two bolts (part number 70923484) to the tandem,
1. Set adjustable torque wrench to 150 Ib-ft (203.34
Nm) and check to make sure tandem does not oscillate.
Set adjustable torque wrench to 500 Ib-ft (677.91 Nm)
and check to make sure tandem does oscillate. Remove
jig.
Step 47: Install sprocket, 1, and fasten with cap screw, 2,
lock plate, 3, and washer, 4.