NorAM 65E Turbo, Service Manual, Page: 392 / 613

65E Turbo Motor Grader
Service Manual
Section 5
Rear Axle and Tandems
Service 1.00_2006.03 5-32
Step 4: Position side gear assemblies with thrust
washers in relevant seat of side gear carrier.
IMPORTANT: Position thrust washer of side gear carrier
on wheel shaft prior to assembling the third side gear,
thrust washer cannot be fitted if assembly is completed.
Step 5: Insert three pins securing side gear assemblies
into side gear carrier. Insert pin lock ring in relevant seat
of pins and, at the same time, widen fit ring and press fit
pins up to match relevant seats on side gear carrier.
Step 6: Insert end play adjustment shim on wheel shaft.
Mount the complete side gear carrier on wheel shaft.
Mount thrust washer, lock plate, and tighten screw.
Position a dial gauge and check end play of side gear
carrier. Fit should be 0.008/ 0.016 in. (0.2/0.4 mm).
Shim as necessary, and check proper adjustment of
end play. Lock fixing screw with a torque of
336/372 Ib-ft (45.6/50.4 daNm).