FORM NO. 56043055 / HR 2800, HR 2800C / BR 700, BR 700C
- 33
SQUEEGEE SYSTEM
FRONT
B
A
C
D
Length of Assembled Rod
8.75"
(222 mm)
SQUEEGEE LIFT ACTUATOR MOTOR REMOVAL
1
Lower the squeegee tool to the floor and disconnect the battery pack connector.
2
See Figure 1. Remove the Retainer Ring
(A)
securing the Lift Cable Pin
(B)
and separate the cable from the squeegee mount.
3
Disconnect the squeegee lift motor wire harness at the motor.
4
Remove the Retainer Ring
(C)
(the one closest to the motor) and slide the Mount Pin
(D)
out from the chassis-mounting bracket.
Then pull the lift motor forward to remove it from the chassis.
•
Note:
All new replacement actuator motors are not shipped with the lift nut preadjusted.
•
Important Service Note:
After removing any actuator motor and before installing a new motor or drive nut the IN and OUT motor
limit switches must be set (or checked) to their correct specifications. Reference the Electrical section in this manual for the Actuator
Drive Nut Adjustments and follow the instructions before replacing the actuator motor.
5
After setting the correct actuator nut adjustments for the squeegee lift motor follow the steps 1-4 in reverse order to reassemble.
SQUEEGEE TOOL BLADE REPLACEMENT
If the squeegee leaves narrow streaks or water, the blades may be dirty or damaged. Remove the squeegee, rinse it under warm water
and inspect the blades. Reverse or replace the blades if they are cut, torn, wavy or worn.
To Reverse or Replace the Rear Squeegee Wiping Blade...
1
See Figure 2. Raise the squeegee tool off the floor, then unsnap the Center Latch
(E)
on the squeegee tool.
2
Remove the Wing Nut
(F)
from each end of the squeegee, then remove the Tension Straps
(G)
.
3
Slip the rear blade off the alignment pins.
FIGURE 1
revised 2/05
Summary of Contents for Hydro-Retriever 2800 BR700
Page 2: ......
