Nikon LV-ECON, Instructions Manual

Page: 22 / 59

20
C-HGFIE
USB
LV-AF TE2-PS100W TE2-PS100W
UEPI2A
100-240V
~
1.2A 50/60Hz
LV-FMA LV-DICA
NOSEPIECE
DIA EPI
EXT-IN
EXT
CONTROL
DC-IN
OFF ON
POWER LED
LED controller
LV-EPILED
LED cable
LV-ECON
Control cable
To connect with the epi illuminator with LED light source
You can perform the bright-field microscopy under episcopic illumination with ease by using the
LED epi illuminator, LV-EPILED. The LV-EPILED has an LED unit as the light source for the
episcopic illumination. And the LV-EPILED can be controlled with the E controller. To connect the
E controller with the LVEPILED, perform the following procedure:
1
Check that the LV-EPILED is mounted on the microscope base (the motorized focusing
module, or such) correctly.
2 Check that the power switches on the LED controller of the LV-EPILED and on this product
are turned off (the “ ” side is pushed).
3
Connect the special LED cable to the connector on the light source and to the LED connector
on the LED controller.
4 Connect the special control cable for the LED light source to the EXT-IN connector on the
LED controller and to the EPI TE2-PS100W connector on the LV-ECON.
If the control cable is connected to the DIA connector, the LV-EPILED cannot be controlled.
Make sure that the control cable is connected to the EPI connector.
5 Move the EXT CONTROL switch on the LED controller to the ON position.
For details about assembly method of the LV-EPILED, refer to the instruction manual for
the LV-EPILED.