40
Diascopic illumination
To light up/down the diascopic illumination and to adjust its brightness, operate the diascopic
illumination controls. This product can control the power supply for the halogen lamp (TE2-
PS100W).
•
To light up/down the diascopic illumination
To light up the illumination, push the DIA button. Each
time the button pressed, the illumination turns on or off.
When the illumination turns on, the corresponding
indicator turns on (or blinks).
Indicator
On
Blinking
Off
Diascopic illumination
The illumination lights up with the brightness
of the preset setting. (It is the adjusted
condition in accordance with the set-up
memory or the interlock function.)
The illumination lights up with the brightness
other than the preset condition. (It is the
adjusted condition with the +/- buttons.)
The illumination is not lit.
•
Brightness adjustment for the diascopic
illumination
To adjust the brightness for the illumination, operate the
+/- buttons. The current brightness is displayed on the
brightness level indicator in steps of eight (1 to 7: green, 8:
orange). When the brightness becomes the upper or lower
limit, a beep sounds.
•
DIA indicator
The lamp status for the illuminator is displayed with the
DIA indicator as described below.
On
Off
Blinking: Brightness other than the preset condition
On: Preset brightness
Brightness adjustment
IV. Operation
Summary of Contents for LV-ECON
Page 1: ...LV ECON E Controller Instructions M374 E 07 1 NF 2 2 3 ...
Page 2: ......
