Nikon LV-ECON, Instructions Manual

Page: 6 / 59

4
WARNING
7. Handling of the motorized devices and the light source
•
Each motorized device will move when this product is operated. To prevent injury, do not
touch the moving device during operation. Before operating this product, check all
moving devices for your safety.
•
If you touch the elevating section or its attached devices during operation of the motorized
focusing module, it may cause injury to hands or fingers. Do not touch the motorized
devices when you operate the product.
•
When a power supply for the illuminator or an external light source is connected with this
product, you can control the lamp and shutter with operating this product. Before
operating this product, check the illuminator and its surroundings for your safety.
8. Heat from the light source
The lamp, the lamp house, and the illuminator become extremely hot. To avoid burns, do
not touch the devices while the lamp is lit or for thirty minutes after it is turned off.
Furthermore, to avoid the risk of fire, do not place fabric, paper, or highly flammable
volatile materials (such as gasoline, petroleum benzine, paint thinner, or alcohol) near the
devices while the lamp is lit or for about thirty minutes after it is turned off.
9. Cooling fan and air vents
Do not block the opening for the cooling fan on the back and air vents on the side. If the
cooling fan or air vents are blocked, the temperature of the product will rise. And it results
in a malfunction, damage, or fire.
CAUTION
1. Handle with care
•
Handle this product with care to avoid shock on impact.
•
Do not forcefully bend, pull or twist the power cord and the cables.
•
Do not drop metal pieces such as clips and staples through any clearance into the product
inside. It could cause a failure of the product or a fire.
2. Do not wet the product
If the product gets wet, a short circuit may cause malfunction or abnormal heating of the
product. If you accidentally spill water on the product, immediately turn off the power
switch (flip it to the “ ” side) and unplug the power cord from the wall outlet. Then, wipe
off the water with a piece of dry cloth. If water enters a component, immediately suspend
use of this product, disconnect the power cord from the outlet, and contact your nearest
Nikon representative.
3. Weak electromagnetic waves
The product emits weak electromagnetic waves. There is a possibility that some precision
electronic devices are affected by the electromagnetic waves. To prevent bad influences,
locate such electronic equipment away from this product. If a TV or radio reception is
affected, move the TV or radio set farther from the product.