3.
Roll out the roofing felt (full roll) and cut out for the bulge,
alternatively for the screws in the sealing plate.
On existing roofs: Mechanical mounting with a minimum of
4 screws and a new covering lip with the minimum format
1,0 x 1,5 m.
4.
Heat the roofing felt through the perforation in the sealing
plate so that it melts together with the underlying felt.
This procedure should be carried out by a professional (bitumen
roofing specialist).
LEK
5.
Install the mounting against the sealing plate.
NOTE
Do not forget the rubber gasket under the adapter.
Clean tar or anything else off the raised surface in order to
achieve the best possible rain seal.
Continue with the mounting rail and solar panel according to
the principles illustrated previously.
If support stands are to be used, install these on the adapter
and the mounting rail above the stands.
61
Chapter 4 |
Mounting
SOLAR FP215 P/PL