2. Pre-install the support stand
The stand is pre-installed and delivered folded. The illustration
shows the stand in the installed position. The stands should
be prepared before mounting on the roof.
The foot rail has 2 oblong holes.
3. Installing the support stand
The mounting of the stand is shown on a sheet metal roof
with coach bolts for securing in the substructure.
NOTE
This requires that the substructure is sufficiently solid
and that the surface coating is flat enough to seal
against the rubber gasket.
This must be determined by the installer from case
to case.
The support stands are set on coach bolts that are fixed with
the upper and lower nuts.
Additional coach bolts can be ordered if necessary.
23
Chapter 4 |
Mounting
SOLAR FP215 P/PL