NF wf1966, Instruction Manual

Page: 55 / 198

3.3 Basic operation
WF1966
3-27
„
Phase setting (
ENTRY
→
PHASE
)
The oscillation starting phase setting for burst and (gated) sweep is described.
Set CH1 and CH2 independently to also allow setting the phase difference between these channels.
“5.5 Other settings ( ■ Phase sync)”, cf.
Operation:
Two methods can be used for setting the phase.
(1) Keypad
Convenient when the phase has been determined beforehand.
For example, set 90 degrees as follows.
①
Press the
ENTRY
key, then the
PHASE
key.
The following display is produced.
Phase
P H S 0 . 0 0 0 d e g
1 . 0 0 0 0 0 0 0 0 0 k H z A 2 . 0 0 0 0 V p - p / O P E N
Frequency Amplitude
②
Press keys
９
and
０
, then the
ENTER
key.
To correct an entry, press the
BS
key before pressing
ENTER
.
③
This completes setting, afterwards, press the
EXIT
key.
(2) Modify dial
The phase can be changed continuously.
①
Press the
ENTRY
key, then the
PHASE
key.
② Select the digit to be changed with the and keys.
③
Turn the
MODIFY
dial to set the flashing digit.
④
After setting, press the
EXIT
key to release the setting mode
.